GONZO my 1982 Freedom 25 sailboat

GONZO my Freedom 25 yacht:
This blog will document the continued restoration of my 1982 Freedom 25 sailboat, along with all the experiences I have. I purchased my F25 in the winter of 2009 from the 3rd owner who had the boat in NH. Gonzo has a composite rotating winged mast, yanmar inboard diesel, a Gun Mount spinnaker pole and staysail. This is my 1st cruising sailboat and I look forward to learning how to maintain and slowly restore and sail in Narraganset.

Tuesday, March 8, 2011

Project list:

Here is my rough list of things to get done before the start of the sailing season in may, I expect this to change but feel a good basic list is important to keep this moving forward.
List:
1. remove and reseat all through hole fittings on hull
2. remove and reseat prop shaft support, and fair into hull
3. service prop shaft seal through hull
4. repair and install all parts to make the 'head' work properly with holding tank
5. reseat all windows, vents and hatchs on boat
6. reseat all hardware and hand rails (inspect for rottan core)
7. reinstall fuse panel with very basic elec, with elec diagram: nav lights, engine, radio, 12v charge station, instruments
8. strip undercoating and repaint
9. service all blocks, and travelers
10. repair chips on mast
11. repair SS ring for bearing on mast
12. repair bottom of mast to except bearing
13. paint all wood in hatches to seal

No comments:

Post a Comment